Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by tepa

  1. tepa

    Shaft tolerance to certain length only

    Thanks for the help! I modelled it with a step.
  2. tepa

    Shaft tolerance to certain length only

    Hello, I have a shaft that needs to be fitted into a hole. The hole depth is only 60mm while the shaft is 200mm long. I dont want to tolerance the entire shaft to a g6 fit, but rather just the section that goes to the hole. How would you indicate this in a drawing? I was thinking about just...
See more

Part and Inventory Search

Back
Top