Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TeoKL
-
Flatness of G10 after milling
Wow, thanks guys. There were a lot information provided. I am new to this industry(and this forum too). The reason my company don't buy the 1mm thick G10 is because there are other things we need to control(surface roughness, tolerance of thickness +-0.10mm). Sorry for misleading, I did not...- TeoKL
- Post #8
- Forum: Material engineering general discussion
-
Flatness of G10 after milling
Is there any methods/tips to improve the flatness of machined G10? The raw material's dimension is around 360mm*360mm*2.0mm, the target thickness for milling is 1.0mm. After that, it will part off to a circular disc with O.D. of 320mm. Significant "bowl up" effect was observed (>0.30mm). Is...- TeoKL
- Thread
- Replies: 7
- Forum: Material engineering general discussion
