Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TDKPE
-
DIN 5482 Splines - Is there a resource to determine lash?
I can't classify the lash as 'excessive' yet. Just that there is lash, which is expected as this is not an interference fit (hand assembled in the field) and new shaft/gear connections exceed the manufacturer's lash specification using their proscribed measurement techniques (again, intended...- TDKPE
- Post #4
- Forum: Gear and Pulley engineering
-
DIN 5482 Splines - Is there a resource to determine lash?
I've got existing spline connections which I am told have excessive lash. What I can't seem to figure out is if lash is somehow included in the DIN standard through tooth thickness and so on, or if the final fit is up to the original engineer to determine and specify through those same DIN...- TDKPE
- Thread
- Replies: 3
- Forum: Gear and Pulley engineering
