Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by tc817
-
-
Asme Obround Calculations
Section VIII division 1 The obround is 1-3/4 thick 48" long x 27"- tc817
- Post #3
- Forum: ASME (mechanical) Code Issues
-
Asme Obround Calculations
In regards to ASME Code for pressure vessels, Does ASME code state or regulate about using calculations for someone else's design as my own? More specifically, I am under a time crunch and have been going back and forth with our AI and engineering in regards to calculations for an obround...- tc817
- Thread
- Replies: 4
- Forum: ASME (mechanical) Code Issues
-
-
Asme Code Calculations
In regards to asme Code for pressure vessels, Does Asme code state or regulate about using calculations for someone else's design as my own? More specifically, I am under a time crunch and have been going back and forth with our AI and engineering in regards to calculations for an obround...- tc817
- Thread
- Replies: 2
- Forum: Drafting Standards, GD&T & Tolerance Analysis
