Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Tahni
-
Welding Symbols Applied to Drawing?
Should welding symbols for fillet welds always be shows perpendicular to the weld bead on the drawing unless you're specifying specific lengths? I'm looking at AWS A2.4 Figure 32 A-E - is the welding symbol applied in that orientation because it's easier to illustrate the point for the document...- Tahni
- Thread
- Replies: 1
- Forum: Welding, Bonding & Fastener engineering
