Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by tabraizzarif491
-
Geeetech A10
thread404-463752 Hi everyone, Is it possible to use OrcaSlicer with my Geeetech A10 printer? I have searched everywhere but I can’t find any info on anyone doing it. I have looked through the list but Geeetech isn’t included. Any help would be much appreciated. Regards,- tabraizzarif491
- Thread
- Replies: 0
- Forum: Mechanical engineering general discussion
