Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SVillagrasa

  1. SVillagrasa

    Using multiple arrows for the same tolerance

    pmarc, Okay it's good to see another person supporting this and I actually found some other figures with multiple arrows the other day when I was looking through the standards. I read about the profile tolerance and I changed the bottom beam (left) to a profile tolerance since it seems like a...
  2. SVillagrasa

    Using multiple arrows for the same tolerance

    I've got the 2009 version, I'll take a look at it. Thank you very much for your help!
  3. SVillagrasa

    Using multiple arrows for the same tolerance

    powerhound: Yes I meant with respect to the B datum. The B datum is bottom surface of the bar on the right and I want to call out a parallel tolerance with the bar on the left as well as a few of the beams above (not shown) in the structure. Dean3W: The features that this will be applied to are...
  4. SVillagrasa

    Using multiple arrows for the same tolerance

    Hey all, I am wondering if it is acceptable to use the method shown to indicate the same tolerance to the B datum for multiple beams in my assembly. Thank you.
See more

Part and Inventory Search

Back
Top