Here are the images of gear motor (1 hp, 40 rpm output, 3 phase), i want to use it for earth auger. for transmitting horizontal to vertical i tried with straight bevel gears but the cost of project increases.
Please comment on using gear-motor vertically.
Suyog Patil
CAD Engineer
NX 7.5. 8...
Hello All,
I want to make a vertical ground drill, for that i got old horizontal foot mount helical gear motor, now issue is that I want it to use in vertical position will it work or i have to make some other arrangement to convert horizontal to vertical rotation.
Editted -- Can I attached...
I want design 7.5 kw air vane pump with 10 m3/hr. But I am stuck where to start.
Do i go shaft--> vane displacement--> rotor --> cam ring --> Casing etc...
as not able to get any literature on same , more centrifugal pump is found.
Suyog Patil
CAD Engineer
NX 7.5. 8, 8.5 9, 10 TC-9
How simulate in design simulation in nx9
if pressure 20bar and vane is rotating and sliding assuming material steel.
I tried but not able to fix the vane in slot portion in simulation.
Suyog Patil
CAD Engineer
NX 7.5. 8, 8.5 9, 10 TC-9
Is there is any shaft generator add on or kf or udf so that it would be easy to calculate and determine the shaft size reduce the time for calculation for shaft sizing.
Like there is one in auto-cad mechanical shaft generator.
Suyog Patil
CAD Enginer
NX 7.5. 8, 8.5 9, 10 TC-9
How to calculate input torque and speed, i want to generate 1 kw of power. I am design a pneumatic motor to drive generator.
and also if speed of input pneumatic motor varies +-300rpm
Suyog Patil
CAD Enginer
NX 7.5. 8, 8.5 9, 10 TC-9
Suppose I have Designed a pump of input parameters speed = 1000 rpm and power 10 kw in NX9
and want to scale it up just changing the above parameters and components should modify according to formulas created while designing the system.
Suyog Patil
CAD Enginer
NX 7.5. 8, 8.5 9, 10 TC-9
Hello,
I want to deliver assly to customer and customer need dumb file i.e components without features. Is it possbile to take assly outside the teamcenter and automatically the child parts features can get removed and part should have only Dumb bodies. but the assly should remain same.
Suyog...
Hello,
As suggested by John i did same thing yet I have to updisplay continously when i zoom in small area for checking.
Suyog Patil
CAD Enginer
NX 7.5. 8, 8.5 9, 10 TC-9
If your surface is muxh complex.
Use snip surface command .. Cut the facet into multiple facet and fit surface on it.
Suyog Patil
CAD Enginer
NX 7.5. 8, 8.5 9, 10 TC-9
