Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Supra85
-
Cannot Linear Pattern Lofted Cut "Unable to create contour geometry, please check the loft sect
Thanks for the suggestion- I just tried it and I'm getting an error that says "The selected features could not be patterned using a geometry pattern." I tried it with and without the tangent faces box checked when creating the loft- is there anything else I should do to make geometry pattern...- Supra85
- Post #3
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Cannot Linear Pattern Lofted Cut "Unable to create contour geometry, please check the loft sect
Hey there. I'm designing a cylinder head, and I have a lofted cut I'm running from the side of the cylinder head to the center of the cylinder head. I get the error "unable to creat contour geometry. Please check the loft section". I tried doing the loft again and unchecking "merge tangent...- Supra85
- Thread
- Replies: 4
- Forum: DASSAULT: SOLIDWORKS 3D Design
