Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by sunshineboy
-
how to avoid spatter sticking from lasering .062 304 ss
I'm having a laser shop cut some parts for me out of 304 ss with a mirror finish. Every start point of the laser on inside cuts of slots that are .060 wide I get spatter that blows out and sticks to the part. Is there a way to avoid this? Thanks for any and all help.- sunshineboy
- Thread
- Replies: 3
- Forum: Laser engineering
