Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by sunil8487
-
B16.5 & SA-522Gr.1
martyr007 your interpretation is correct. You can do that way but in that case you wont be allowed to stamp ASME B16-.5 on that flange. ASME Sec VIII will allow you to use that nozzle flange- sunil8487
- Post #4
- Forum: ASME (mechanical) Code Issues
-
SA193 B8T CL1 bolts failing in the hydrotest condition.
I has used the SA193B8T CL1 bolts for the girth flange, for a heat exchanger that i have designed. the bolt material was specified by the client itself. it was ok in my calculations run on PVElite. But when in actual condition the hydro is being conducted the bolts are getting elongated as they...- sunil8487
- Thread
- Replies: 3
- Forum: Boiler and Pressure Vessel engineering
