Thanks John. Arragements are very handy, it just seems like this would be the next step for them.... If you revise a standard base level assy to add arrangements, you can't get the benefit of this improvement at the top level assy until you revise all sub-assy's. --- Thanks again, Billy
I have read a few post on NX6 arrangements and have not found the answer that I was hoping to see... When an arrangement is created at assy level A, then I add Assy A to Assy B, but do not create a new arrangement in Assy B to carry up the arrangement from Assy A. If I add Assy B to Assy C, I...
That was the conclusion that I was coming to.... If I re-define the parameters then every assembly that this deformable part was used in now looses assoiciativity and gets a feature added in its place. That is not good!
I am trying to learn about deformable parts in NX6 (NX6.0.2.8) I have successfully defined a part and added to an assy where I can deform as I desire. My problem comes in when I want to modify the parameters of the original deformable part to increase the original range(not in the assy as a...
