Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by StuartMurray
-
Wastewater bypass, Contractor wants to use fitting to bypass a MH the are replacing, Thoughts?
Situation: 15"PVC line with peak flow estimated at 4500gpm, contractor proposes using 45degree PVC bends to bypass MH they are replacing. They plan to set up a standard "pump around" bypass for 24hrs to allow high early strength concrete to cure. Replace MH, vacuum test, and coat; then reset...- StuartMurray
- Thread
- Replies: 2
- Forum: Waste disposal & treatment
