Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by StressPE

  1. StressPE

    Div 1, Code Case 2695

    Dear All, I have few nozzles which need REPAD . shell thickness is either 3/8",0.5", 5/8" or so and nozzles are 18" , 10" or so . material is with 304ss or 516-70 . When I turn on Code Case 2695 design case in Compress software for nozzle, The primary stress is lower than allowable stress...
  2. StressPE

    Tower Downcomer

    I already put rest support under the elbow . In EXP load case , this support lifts off. however I don't have any problem regarding code stresses,alt stress etc. . my problem is Mx on the nozzle . Please pay attention to the fact that the tower brings the downcomer down due to low temperature ...
  3. StressPE

    Tower Downcomer

    I have a downcomer from a cryo tower to a Al-Brazed heatexchanger. The downcomer as seen in the attachment is 45 ft tall with 9ft LEG. Tower and HE modeled to apply true displacements on the boundary condition. However, The line is working in two different mode ( Temperature) . When I design for...
  4. StressPE

    Deficiencies for Skirt Opening

    Thanks for your reply. Generally speaking when we use skirt support instead of Legs. in my case the vessel dia is 24" and the height is 24'
  5. StressPE

    Deficiencies for Skirt Opening

    Dear All, How can I resolve below deficiency ? my standard drawing from Customer says to consider 12" sleeve on skirt for a 4" flanged pipe outlet . But if I go higher than 6", I receive below deficiency! How can it be resolved? my tower(skirt) diameter is just 18". Any prompt help is highly...
See more

Part and Inventory Search

Back
Top