Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by StianAndersen
-
My part file (in NX) partly disappear when rotating it
Thank you 1000 times! You are the best :)- StianAndersen
- Post #5
- Forum: Siemens: UG/NX
-
My part file (in NX) partly disappear when rotating it
Thank you for your fast reply. Can you please tell me where to find where to adjust this? Was looking at Menu - tools - Vehicle Design Automation - Vision model - Direct field of view. But this didn't make me much smarter im afraid :( is there a specific place to punch in some numbers, or is it...- StianAndersen
- Post #3
- Forum: Siemens: UG/NX
-
My part file (in NX) partly disappear when rotating it
Hello I just started to learn Siemens NX and im having a problem. When I make a part and Im rotating it to have a look it partly disappear (the edges). It should not be due to my graphic card, couse its a very good one. I red somewhere I had to go Preferences - Visualization performance - and...- StianAndersen
- Thread
- Replies: 4
- Forum: Siemens: UG/NX
