Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Stewborn
-
Lofted Cut with Guide Curves Failure
Yes, I see what you are talking about now. I will try using a loft instead. Thank-you.- Stewborn
- Post #3
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Lofted Cut with Guide Curves Failure
In the attached Solidworks part, I cannot complete a lofted cut from Sketch12 to Sketch13, using the curved edges of the body as guide curves. The preview of the cut looks good and the same type of cut worked fine on the first half of the body (up to Plane2), but when I try to cut the remainder...- Stewborn
- Thread
- Replies: 2
- Forum: DASSAULT: SOLIDWORKS 3D Design
