Hi there
I have three channels modeled using swept feature. I want to connect them with a nice looking blend.
Normal Edge Blend doesn`t satisfy me but it works fine when I want to offset the blend surface
Styling Blend from the other hand satisfies me but it doesn`t work when I want to...
I don`t know how to add two attachments to one post so I put it herehttp://files.engineering.com/getfile.aspx?folder=aa63d317-1ba9-44b6-9af6-b3f25a7fa2a1&file=spiral.png
Hi there
What would be the best way to wrap a curve ( spiral ) on a surface ?
I attach the prt file as well as a paint sketch.
I have been trying to use a wrap curve but it doesn`t work on a multiple face sheet. Also the surface size changes from bottom to up which might be a challenge.
Any...
Hi adkad
Thanks for the tip but
geometric progression works fine but only when you have progression. It will not allow me to place points as "percentage subtype" where I have a list and I could put 33%, 66% and for example 55% in one feature.
Although I could do it in two/three separate...
Hi
I`m trying to create two points on a spline curve at the 33% and 66% of the spline lenght
I use Point Set - Curve Points and Curve Percentage Subtype.
It creates points but when I later on divide original spline with created points -> divided curves are not equal.
Even when you look at the...
Just found out the answer.
If you do Derived Curve -> Intersect and then Project it into Sketch - then Offset Curve inside the sketch does not work
If you do Derived Curve -> Section and then Project it into Sketch - then Offset Curve inside the sketch does work
I don`t know why but it is as I...
Toost - it works really good.
It doesn`t create a chart but this isn`t a problem.
Guide curve is mandatory for such analysis so it will not work with imported ( from stp ) pipe bodies but I guess this would be too much to ask.
Thanks
I looked for this problem and it seems that someone has already asked it on a forum but unfortunately didn`t get an answer
The problem is with offset curve in Sketch environment. I projected some curves into sketch and wanted to offset them. I get a message saying "Offset is not well-defined...
This was only an example. Imagine you have a pipe surface ( from a stp file ) or a simple Through Curve surface. How would you check that section is changing in linear way ?http://files.engineering.com/getfile.aspx?folder=40ea3c5d-9cd5-4aa7-95bc-c5835eae0592&file=area_section.prt
Hello
I`m trying to find a feature which allows me to check how the section ( mm2 ) of the pipe changes along the guide curve ?
I have a Swept feature. One section at the beginning and one section at the end. I created a surface using these two sections and a guide curve. I used Scalling...
Hi
I`m using NX10 and trying to make a Swept which will be tangent to first, and last section ( similar to Through Curve Mesh where you select surfaces to be tangent with ) and also I want to control its shape by a spine curve ( spine curve is perpendicular to first, second and last section )...
