Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by stevenj17

  1. stevenj17

    Very Slow Print Performance in XM

    Cheers Cadman ;-)
  2. stevenj17

    Very Slow Print Performance in XM

    Gday Guys and Gals I just converted to Microstation XM. Compared to V8, print performance is EXTREMELY slow. Painfully slow. Im not sure what the problem is. Whether it is simply linework or aerial photos, printing to a printer or creating a PDF, performance is rediculously slow. Any help...
  3. stevenj17

    3D Piping Cell Library w/ Spec Fittings - Suggestions?

    i havent seen any of them around mate, but i suggest making your own 3D cells, especially if you are going to use them frequently.
  4. stevenj17

    Boat Hull

    Ive done this before using the plans from a Maratime Museum. They plans were incredible for their age, and they provided a cross section. I plotted each cross section using a B-Spline Curve. Make sure you set your depths correctly (so that the curve remains 2d) and then set them a certain...
See more

Part and Inventory Search

Back
Top