Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SteveK68

  1. SteveK68

    2205 Stainless Steel Corrosion rate

    The temp ratings are in F. I will try and get the specific chlorinated solvent our customer is using. Thanks,
  2. SteveK68

    2205 Stainless Steel Corrosion rate

    The pH factor for the hydrogen peroxide @ 33% is 4.7 and the temp we run at is approximately 100 to 120 degrees. The hydrogen peroxide is in vapor state, heated to approx. 200 degs and cools to 100 degs with sterile air. Thanks,
  3. SteveK68

    2205 Stainless Steel Corrosion rate

    We have a customer who uses 316L material in a 33% concentrate hydrogen peroxide chamber. The chamber and the components inside the chamber are cleaned with a chlorinated solvent. He’s having excessive pitting problems on all the components that are cleaned. Is changing the material to 2205...
  4. SteveK68

    3D models of Sanitary Clamp fittings?

    Thanks. I still haven't found anything yet.
  5. SteveK68

    3D models of Sanitary Clamp fittings?

    Does any one know where I could find a library of sanitary clamp fittings for SolidWorks? (Clamps, gaskets, ferrules, reducers, etc...) I've tried to contact Cherry-Burrell, but no one seems to want to call me back, and the book has very limited dimensions. Any help would be greatly...
See more

Part and Inventory Search

Back
Top