Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Stephen Robertson
-
Compound datums for hole intentionally not perpendicular to surface into which it is drilled
Is this use of compound datums correct (see uploaded image)? The holes are features drilled into a drafted surface, but for easier machining set up the holes need not be perpendicular to the drafted surfaces (a very slight ellipse will be fine for the cable gland). This leaves no surface to...- Stephen Robertson
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
