Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by StainlessSteelyDan

  1. StainlessSteelyDan

    Cutting 4" Acrylic

    Hi, I dont know much about it. The only thing that comes to mind is the kerf problem you would have, at least on a laser. If you cut a six inch square the top would be six, but the bottom would be much smaller. I dont think a laser is the way to go on this one. D
See more

Part and Inventory Search

Back
Top Bottom