Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by SRoswurm
-
Enercalc + Revit
dold, Concerning modeling accuracy, you'll find that there's a lot of flexibility and intelligence built into EFR's process for interpreting model geometry. In addition to proximity tolerances, you also have the option in extreme cases to instruct EFR to compute extrapolated connection points...- SRoswurm
- Post #13
- Forum: Structural engineering general discussion
-
Enercalc + Revit
driftLimiter, Absolutely! The ability to automatically move reactions from one calculation to another was a must-have priority during development. When you launch a calculation in Revit, you'll be prompted to briefly verify the support conditions that ENERCALC uses to establish span geometry...- SRoswurm
- Post #11
- Forum: Structural engineering general discussion
-
Enercalc + Revit
Afternoon All, @CConrad looped me into this thread so that I could answer some of the questions being raised here. I'm the lead developer and senior structural engineer (PE, SE) responsible for the creation and maintenance of the ENERCALC for Revit (EFR) product line. I'll start by tackling...- SRoswurm
- Post #7
- Forum: Structural engineering general discussion
