Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by squarecircle

  1. squarecircle

    centroid

    Ouch, no edit here. The three holes are called out with a true position.
  2. squarecircle

    centroid

    ringman, "I am wondering why you apparently do not use positional tolerances on the three outer holes." The three holes are called Datum B. That hole pattern being called out as a Datum drives the Datum to be the centriod. However, the three holes are unequal distances from the theoretical...
  3. squarecircle

    centroid

    I have two rings, one inside the other. A material is injected between them that holds them together as a single assembled ring. Their surfaces lie on the same plane. The outer ring has three holes on its face that are dimensioned using x and Y dimensions and are unequal distances from the...
See more

Part and Inventory Search

Back
Top Bottom