Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by SpringHalo
-
Differential motion simulation
I figured out the problem; the origins of the two linked pieces of the revolute joint (the fixed bit) have to be at the exact same point, and the revolute joints both need to be with respect to the same object (so the two spurs need to "revolve" around the outer bit even if they aren't touching)...- SpringHalo
- Post #3
- Forum: Siemens: UG/NX
-
Differential motion simulation
I'm attempting to make a tank differential system similar to this one and figured out how to get the gear modeling application in NX, and how to work it, but now I'm struggling with the motion simulation. I'm sure the two driving gears are supposed to be revolute, and the outer gear should be...- SpringHalo
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
