Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by spehrg

  1. spehrg

    NX8 Drafting - Applying common datum reference to FCF

    I don't know of a way to change the FCF by inheriting from another, but you could define a part attribute for your primary, secondary, and tertiary datums. Then you would insert the attributes in the annotation editor each time you created a new FCF. If you have to change the scheme later, you...
  2. spehrg

    Save-as to new revision w/o closing drawing? NX7.5, TC8

    Walterke, thanks for the response and I would agree with you. However, it is frustrating when something changes from one software revision to another for no apparent reason. I am suprised that no one else has run into this problem. There are many customer default settings that control the...
  3. spehrg

    Save-as to new revision w/o closing drawing? NX7.5, TC8

    I have searched the forum and cannot find a solution to this problem. In NX5 I could load a non-master drawing and make changes to it. Then I could switch to the master model and perform a save-as to the next revision and all was fine (drawing and model revsions are in sync). After moving to...
  4. spehrg

    Save-as w/o closing drawing? NX7.5, TC8

    I have searched the forum and cannot find a solution to this problem. In NX5 I could load a non-master drawing and make changes to it. Then I could switch to the master model and perform a save-as to the next revision and all was fine. After moving to NX7.5 and Teamcenter 8, this is no longer...
See more

Part and Inventory Search

Back
Top