Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Spayball

  1. Spayball

    TOC Analzyer

    Hey, just looking for a bit of diretion. Need to complie a list ot tests in order to validate a TOC analzer, where do i start?
  2. Spayball

    PUW Suface Finish

    Great Quark, Would be most greatfull to hear what ASME BPE technical guy will say. And yes i had read through the relevant sections, Hygienic design connections,dead legs etc have been taken into consideration. Keep me posted. Thanks
  3. Spayball

    PUW Suface Finish

    hey quark, Thanks for you supporting comments, got the go ahead from validation to proceed with piping, thank again
  4. Spayball

    PUW Suface Finish

    Thanks quark. But what i ment to say is that it is only the pipes prior to the pre treatment that shall be of a surface finish of 0.8Ra microns. And every part of the system (RO , EDI and UV shall be within ASME BPE 2007 standard. So would this matter since all colonys would be destroyed during...
  5. Spayball

    PUW Suface Finish

    hey Looking for a bit of help here. Surafce Finish for a Purified water system, I know the ASME BPE 2007 standard calls for a surface finish of between 0.38 to 0.64 micron Ra for mechanically polished parts. But what i am wondering does this surface finish need to be the same in the pre...
See more

Part and Inventory Search

Back
Top Bottom