To make threads look like threads, you need to add a helical sweep cut or protrusion to the model with the correct thread parameters, like pitch, major OD and minor OD etc...
As for the black edges... Sorry but I don't think there is a way to do it.
Best of luck,
Bob
This type of message usually appears when the base surface is too curved to create the offset surface or thickness for the solid protrusion.
If you get this message, start by making the offset surface or thickness smaller. Keep going smaller until the offset is created. Then try to increase...
Another approach is to use the "master model" technique.
All child models will reference the master model parent. Make a change in the master model and regenerate the child and the child is updated.
Bob Schwerdlin
onlydrafter... You da' man !!! (or woman)
You had the correct answer !!!
I tried your approach and it worked great !!!
I had to think about it for a bit, but I realized that Pro/E in it's infinate wisdom asks for how many rows in the hole table, not how many columns I want the table divided...
No... You mis-understood the problem.
This is a Pro/E "hole table" not a regular table.
Hole tables can be created by adding "holes" NOT cuts to a model and then creating a "hole table" on the print by having a coordinate system that the table refers to. In the...
Hi,
I've got a drawing of a part that contains a large hole table. The part is a "heatsink" for an electrical device. there are about 75 holes in the part.
I have no problem creating the hole table on the print, but because of the large qty of holes, my table line spacing is quite...
