well, I will make a few more things clear. The gap that i have mentioned in the figure contains a magnetisable fluid. When the fluid is magnetised, torque is transferred else its a free system with no torque transfer..The magnetisation of the fluid provides the resistance to motion till a...
Hello there,
Please take a look at the attached pic. The sun has 20 teeth,planets(3) have 16 teeth and the ring has 52. The planetary gear ratio(teeth no .ring/sun) is therefore 2.6 . The ring gear is the input of the driveline and the planetary carrier is the output. when the clutch is...
some more info on the device. The cylinder shaft arrangement actually simulates the drive train of a vehicle. The cylinder contains a planetary gearset. For torque transmission, the two parts of the planetary gear set are held together by magnetising. The electromagnet also contained within the...
Hi Bob,
The torque is measured using a torque sensor which measures the torsion on the shaft.the shaft has a rotating cylinder inside which the electromagnet is contained. I cannot send a pic of the device as the work is confidential.
I have a simple question on finding the point on an inclined line(different inclinations) where the slope changes.
solver : fixed step ode 1. sample time = 0.001
I have an attachment of the diagram. I want to know the value of the signal at points where the the slope changes. This I did by...
Hello,
Could you please look into the attached picture and tell me what are the possible reasons for the Torque to reach its maximum long after current ? ...Thanks
Hello there,
I have a question on finding the reaction time on eddy currents.
I have an electromagnet(iron core with coils wounded in slots on it). Its contained in a rotating part. The magnetising signal is a current ramp.When the magnetising current is increased at a very fast rate (rate of...
Hi,
I have a planetary gear set with the ring as input and planet as output. The sun is connected and disconnected from the ring(Sun does not remain stationary alone. it moves with the ring on application of the clutch). the shafts of the ring and the sun are connected to disks. Between the...
Hello there,
I have a planetary gear set where the input is the ring gear and output is the planetary gear...none of the gears are fixed...but the shaft of the sun gear experiences resistance to its motion as a result of spinning inside a viscous fluid. The gear ration...zring/z sun = 2.7...
Hi there,
Matlab 7.02 apparently doesn't have the sawtooth function(i actually need triangular wave - i use the sawtooth function with the factor 0.5 to make a triangular wave out of a sawtooth. can someone tell me how I can generate the wave on simulink using mathematical functions. I have...
