Recent content by sonewone

Hello, I have an application for a right angled clinch nuts. I need to know if there is an alternative to this (see link) link : http://www.pemnet.com/fastening_products/pdf/radata.pdf The nut in the attached link needs a rectangular hole punched before clinching the nut. I am looking for one...

Hello, I am working on mechanical design of the PSU (150W) components like housing, end caps etc. I am planning to consider plastic end caps with metal housing. Reason : faster prototype, electrical insulated, slightly flexible etc. Any of you see any issues in this combination in regards to...

Hello, I am working on mechanical design of the PSU (150W) components like housing, end caps etc. I am planning to consider plastic end caps with metal housing. Reason : faster prototype, electrical insulated, slightly flexible etc. Any of you see any issues in this combination in regards to...

That might be a good feature. Sketches to behave like a model edges. Hide when behind a face. Cool thought. I believe its not currently in SW, can be an enhancement. Thanks

I am not sure if this is a solution. Try using a split line to the first hole to generate a 2 more lines. Not sure about the second problem. I think you should also try an Ansys forum.

Mike, Thanks for the right click tip. It does save a lot of time & mouse clicks :)

I tried the tab key, it doesn't work. Also, when I try selecting it continuously, it wouldn't automatically change focus to the next selection box.

Hmm... Macro sounds good. Will try to see if it helps, thx.

I like the results of full round fillet feature. Its like the tri-tangent fillet. How can I speed up the face selection. Each instance of the fillet feature takes 3 faces (1 per selection box). I have to move the move a lot (Face, selection box, face, selection box, face & selection box) for...

Nope it isn't :) I have tried to look up, but in vain. If some one has used an alternative (Preferably with a smaller foot print), I wish they could share it here.

Try changing the selection sequence. Selecting the other plane first & then the plane in the body.

There is always custom views you can save in pv360.

Awsome, Thanks a lot for the links.

We generally use the photo controls from http://www.ripleylightingcontrols.com/ I am looking for any others with smaller foot print. Can any one suggest aternative? Thanks

Sorry I forgot to mention about the alternative Plastic heat sink I am planning to use. Its from www.Coolpolymers.com . By using this, I need not worry about using insulation material while fastening. Another alternative I thought about was to laminate the metal heatsink. This saves the time we...