Hi John,
We hope NX7 will fix the problem, if i may ask, are there other users that have encountered this same problem?
Is it an NX6 problem?
We would like to know so we can rule out our internal structure.
Thank You
Hans
Hello John,
Happy Labor day, we have been told that the 29th of September would be the NX7 release date, we can't wait! we are loosing data at an alarming rate, we have sent more data to GTAC, could you find out if there is a work around for now? we have a tremendous amount of data in NX6 so...
Hi John,
"ID" symbol is perfect, the menu icon shows exactly it's intended use for a BOM or you can use it to ID anything else.
Design0058,
I go back to V-7, that old PFK was very fast, especially after one memorized the pattern, type in your commands fast enough and you could sit back and...
design0058
Using the keyboard hit (Ctrl t), pick your object,on the menu hit OK,pick mirror through line or plane, pick your choice in the model,next menu that comes up is the old transform menu and you are good to go, it is fast and as you know you just hit return and move as you always did in...
Hello John,
Sent data to GTAC, John, i can send you the PR #'s if you'd like, no resolution yet, we were told it needed to go to development.
Everyone at our Company has had lost data due to these errors, in some cases we are unable to open the file again,
we back up every 15 minutes so we are...
Thank you for all the advice, heal geometry works, part cleanup does not in every case, removal of parameters is a none issue most of the time, we have gone back to 6.0.2.8 on
my lap top and no problems encountered, we will send data to GTAC, i will let you all know the outcome.
Hans
John,
Getting a lot of error notices trying to split, trim, subtract, unite, file becomes corrupt, can be exported as a Parasolid, brought back into NX6 into a newly created file and still not work, working in history free mode,the file is now corrupt, imported older versions of UG, non native...
