Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Soloturk
-
NX Cross section isn't (dynamically) updating after Datum Change
reference: thread561-370691 Hello, I often create x-secs in NX by using pre-defined Datum(s)of mine. But once those datums are being altered (new angle, distance etc.), I can't see simultaneously the effect on the x-sec. Instead I need to go the x-sec window back and select (altered) "my Datum"...- Soloturk
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
