Number of mate/demate cycles would be 1-10, connectors would be tucked away, skilled workers. It sounds like turning my search to "quick connect terminals" and similar would be my best bet. Thanks!
I'm a mechanical engineer but I've been tasked to find a connector to join the ends of two 28g wires in modular fashion--i.e. they need to come apart and go back together, so soldering/crimping/etc. are out. I'm envisioning something like a tiny (around 0.125" diameter) banana plug, but after...
I'm looking for an off-the-shelf "rubber band" to use for sealing the casing of a prosthetic component. The band would sit in a shallow groove on the exterior of a part to basically hold two halves of a cylinder together. The outer circumference is about 11 inches and I'd like the band's cross...
Thanks for the input, I would ideally like something that doesn't have to go through the chain link (like an s-hook) and I need something a little stronger than bead chain (about a 70lb load). The way grab hooks allow chain to be secured by putting a link in sideways is what I was looking for...
I'm looking for a small hook that will allow a chain (1/16 or 1/8) to be adjusted and secured on each link. Grab hooks would be perfect if it was smaller, but most seem to be for heavy duty applications. Is anyone familiar with what type of hook/fixture would work for this application? Thanks
