Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by snsyde

  1. snsyde

    NX5 Saving WCS to IGES file

    Thank you. This worked for me. Still not perfectly ideal, but good enough to work with.
  2. snsyde

    NX5 Saving WCS to IGES file

    Thanks for your response. Unfortunately, using Format > WCS > Save does not have any effect. The iges file still retains the aircraft coordinate system. Drawing reference lines won't work either. The coordinate system of the iges file needs to be based on features of the part that we can...
  3. snsyde

    NX5 Saving WCS to IGES file

    To clarify this a little bit... Our parts are created with Solid Edge in aircraft coordinate system. To measure them with our Faro arm we need a coordinate system on the part. In the past we have exported an iges from Edge and created the coordinate system with Solid Works. We are transitioning...
  4. snsyde

    NX5 Saving WCS to IGES file

    When I move the WCS in a part file and save as an IGES file the original WCS is retained in the IGES file. Is there any way to do this without actually having to move the part?
See more

Part and Inventory Search

Back
Top