Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by smart2021

  1. smart2021

    Trim weight calculation for two plane balancing

    Hi electricpet, I tried this option2 to calculate trim weight, Just let me know if I understood wrongly I took Vibration amplitude of Plane I & Plane II after adding balance weight at both locations at the same time as Voriginal and replaced this value with Initial vibration value in the IC...
  2. smart2021

    Trim weight calculation for two plane balancing

    Hello All, Thanks for your replies. @GregLocock Correction weights are nothing but balance weights which are obtained after the initial,trail 1 and trial 2 runs. The trimming of these balance weights are trim weights. As stated by electricpete I'm confused in calculation of trimming...
  3. smart2021

    Trim weight calculation for two plane balancing

    Hi all I have a 2 plane balancing software which calculates correction weights using the influence coefficient method. But it does not calculate trim weights. I would like to calculate the amount of trim weight I need to install after trim run. Some of the commercial analysers does this eg...
See more

Part and Inventory Search

Back
Top