Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SLG

  1. SLG

    API 510 STUDY GUIDE

    I just think that the NBIC test is a little more complex than I am ready for at this time. I am only a CWI without a lot of mathematical strength, but I am contiuosly trying.
  2. SLG

    API 510 STUDY GUIDE

    ARE THERE STUDY GUIDES FOR THE API 510 EXAM THAT CAN BE REVIEWED ARE STUDIED FROM AN INTERNET SITE.
  3. SLG

    Mazatrol send and receive via rs232

    I have three Mazak lathes with T-plus controllers. I use the Windows terminal program to up-load and down-load programs. It works fine. I'm not sure if the older 32 model controllers have the same capability. I would reccomend giving Mazak's headquarters in Kentucky a call. They have a tech...
  4. SLG

    HELP! Which CAM software to purchase??

    AVOID the Teksoft ProCAM software like the plague. I have been using ProCAD/ProCAM for nine years. The software is always full of bugs, always has been. The latest version, ProCAM 2, was released in November of 2001. Here it is August of 2002 and the program still will not allow you to print...
See more

Part and Inventory Search

Back
Top