Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by skyline7509

  1. skyline7509

    Can tolerance value bigger than nominal specification?

    I encountered a dimension with 0.004 +0.007/-0.015 (units: inches), meaning the lower spec will be in negative value. Is this acceptable for tolerance value bigger than nominal spec? See attached picture. Hope experts can enlighten me. Thanks
See more

Part and Inventory Search

Back
Top