Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by skrowdilos_resu
-
Weldment assembly, GD&T to make surface parallel to hole pattern?
Hello, What would be an appropriate GD&T to use to make sure item 1 is aligned correctly to item 2 for tack welding? Thanks- skrowdilos_resu
- Thread
- Replies: 2
- Forum: Drafting Standards, GD&T & Tolerance Analysis
