Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by skjnj
-
-
Wave effect in 2D machining.
Guys, Need some help in programming 2D contour/profile with wave effect in Z azis. I have only 2mm gap between bottom of part and top of fixture, want to move cutter in z axis constantly up and down to give a ramping/wave effect. Apreciate your ideas and suggestions. using NX5.0 Thanks in...- skjnj
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
