Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ska7ch

  1. ska7ch

    Advice for this part please and a couple of other niggling questions - ISO/BS8888

    Hi there guys, Just looking for some feedback/advice on the drawing attached. It's the spider component for a custom universal joint. The intent of the part is for the position of the 2 opposing spigots to be tied up nicely WRT each other and the level of perpendicularity of the 2 other...
  2. ska7ch

    I have some very basic GD&T questions....working to ISO/BS8888

    Thanks for the reply Belanger, as I suspected regarding the indirect control...say the opposing face was opposite a Datum would there be any implied parallelism then, if so what? Have you any thoughts on my 2nd question? Thanks
  3. ska7ch

    I have some very basic GD&T questions....working to ISO/BS8888

    Hi guys, I consider myself to have a fairly good handle on GD&T (except for these little queries) and have been trying to implement it over the past few months, however got a couple of niggling questions hopefully someone can answer. 1.) Say you have a rectangular block with a size dim across...
See more

Part and Inventory Search

Back
Top