Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Silvio Zanni
-
ASME BPVC tolerances
Mike, grateful for your help! Regards, Silvio- Silvio Zanni
- Post #7
- Forum: ASME (mechanical) Code Issues
-
ASME BPVC tolerances
Ops! Tanks Mike and TGS4- Silvio Zanni
- Post #5
- Forum: ASME (mechanical) Code Issues
-
ASME BPVC tolerances
TEMA code is not applicable because the tubesheet in question has a Ø 8000mm. We found a difference of flatness of 66.0 mm in the heat exchanger assembly, after the tubes positioning. Which I believe to be exaggerated, but I did not find references to linear tolerances for tubesheets. My...- Silvio Zanni
- Post #4
- Forum: ASME (mechanical) Code Issues
-
ASME BPVC tolerances
Dears, i need informations about heat exchanger tubesheet flatness tolerance (requirement). It is a vertical heat exchanger, Ø 8000mm.- Silvio Zanni
- Thread
- Replies: 6
- Forum: ASME (mechanical) Code Issues
