Recent content by ShirleyB463

My opinion is that is was OK for the basics, but not so much for advance training. The other thing I didn't like was the time limit. I think you should pay for the educational material based on the content, not the time. We had a big project come up and I didn't get to finish the last course.

Not sure if this is the same issue or not. We had a similiar problem with our ftp site. The 32 bit worked fine, but the 64 bit would not bring up everything, when we looked for files. You could check and see if you are running a 64 bit ie. Like I said, might not be your issue, but I am just...

John, yes I am also working in NX7.5, we will contact them. Jerry, I tried printing to a PDF printer, and got the same issue. But if it is a drafting issue, I can see why that would happen. I will just have to print as a wireframe, or export a DXF and open in another CAD program, until this...

drawing

Yes I am at 64 bit. I am actually exporting right from NX to a pdf, not through another program. Can I use another program?

When I export to a pdf file, my shaded views that overlap lose their shading. See attached. Is there a way to prevent this?

Sounds good, we have already installed 7.5, so I guess I can just install the update then. thanks

OK, I need help upgrading NX. a previous thread said the heirarchy is: Full release (7.0.0.0) - check Point release (7.5.0.0) - check Maint Release (7.5.4.0) - cannot find Maint Pack (7.5.4.4) - downloaded I understand that. I downloaded the 7.5.4.4 Maint release and...

Thanks, that page was alittle confusing to me, but I did find it.

We are having this problem, when is the next release of NX 7.5 going to come out? This is a real pain to redo views, because you add a new sheet. Solution Center -------------------------------------------------------------------------------- Previous Doc Next Doc...

sorry I hit submit before I was finished. I sent a picture of my print settings to engineering.comhttp://files.engineering.com/getfile.aspx?folder=c77a69df-7787-4a01-96c3-8e921ce34781&file=print_settings.bmp

Thanks John, the visualization worked. As for the printing, I still can't get that to work.

1. I am running NX 7.0 and forgot where the setting is for view resolution. My circles look like triangles and squares. Can you tell me where to look? 2. Is there a setting that allows you to print shaded views? My print setting "Output" only shows color wireframe and b&w wireframe. I used to...

Thanks for your help John. And I will keep that in mind with the Chiropractor :)

Thanks for your help John. And I will keep that in mind with the Chiropracter :)