Recent content by shervin2011

Dear C2it , As your last help, your hint was what I was missing. I do believ in your skills ;-) Big thanks. Cheers, Shervin

Dear C2it, Thanks a lot for your info. It was a real help to me. After reading that section I noticed that flange geometry ( D.O, D.I, thickness ) should be just determined by experience and then do calculation to find out whether stress amounts are valid or not. But is there a way to start...

Hi All, I need to design a custom made flange, which section of ASME I can use or any other method? Thanks for any help

Thanks Bignch, It was such an organized website.

I need to design a flange for carbon steel 54" duct. flange: ASME B16.5 class 150. Is there any formula or chart for that? Thanks for any help.

Thanks a lot rmw.Actually you gave me an helpful hint to start.

Hi All, I need to calculate axial & lateral displacement of specific location on a tank wall due to heat,In fact this is a location where an expansion joint will be installed and so I will find out about displacement of expansion joint place. I do appreciate any help. Thanks