Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by shefer
-
multi-shot injection molding
Hey everybody I'm a polymer engineer working in a Plastic injection molding factory.my company wants to buy multi-shot machines and my job is to investigate about these technologies.these multi-material process are quiet new to my country and there is a little information about it here.I've...- shefer
- Thread
- Replies: 0
- Forum: Plastics Engineering general discussion
