Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Sheeni

  1. Sheeni

    Please Heeeeelp!

    This looks very interesting Peter. I will have a deeper look into it and see what I can make out. Thanks.
  2. Sheeni

    Please Heeeeelp!

    Hi Peter I have a lower version of mathcad so i can't view your document. Please can you save it with a lower version and resend it? thanks.
  3. Sheeni

    Please Heeeeelp!

    Hi Peter, I have attached a word document too maybe you'll understand better what I want to achieve. I have modelled a resonator used for broadband measurement. The fundamental frequency is 1.25 GHz and has other modes as shown in the file attached. What i want to do is to reproduce what is in...
  4. Sheeni

    Please Heeeeelp!

    Thanks Peter for your effort. This not exactly what I have in mind. If you look at my code, I designed the resonant frequency of my resonator to length 83.8 mm which resonates at a fundamental frequency (f0) of 1.25 GHz. So what I have in mind is to plot S21 for 6 modes and have peaks for S21 at...
  5. Sheeni

    Please Heeeeelp!

    Hi Peter, I must confess you are a GURU! LOL! I have been able to plot my P0(f) after following your advice, thanks. Though both S21_0(f) and P0(f) look alike, which I don't think should be, I should be able to figure it out easily. What I need now is the Q0. I have attached the xmcd file as you...
  6. Sheeni

    Please Heeeeelp!

    I have made good progress, thanks man! But there's one or two things left. I have done for one mode as you will see in my program (attached). How do I make more than one mode appear. You will see that I manually put Q0(1) in the equation S21_0(f) and that's why I have only one peak representing...
  7. Sheeni

    Please Heeeeelp!

    Dear pstuckey, I have tried what you asked me to do but it didn't work. The system displays "Mathcad Application has stopped working - close program" and then shuts down. What do you think is responsible for this? Do you think my program is not correct somewhere? I've tried to figure out where...
  8. Sheeni

    Please Heeeeelp!

    I have changed some things in the original file I sent and now it's a bit more plain and simple. the program is shown in the attached PDF file. I want to plot S21_0(f) and P0(f) as shown in the new file I have attached but I could not do so. Any ideas where the problem is? Could you help me to...
  9. Sheeni

    Please Heeeeelp!

    I am writing a program for a resonator. The code seem to be wrong somewhere at the end of the program and I can't figure out how to correct it. Please, kindly help me. I have attached it so you can view and see where the problem is. Thanks, Sheeni.
See more

Part and Inventory Search

Back
Top