Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by shaunlane
-
Preserving design intents
Hi there. i agree with those above who state that if the part is functional and has been tested then the part drawing could be changed for good. Tolerance build ups should be investigated during product design first of all and the part drawing dimensioned accordingly. If this was done properly,I...- shaunlane
- Post #16
- Forum: Mechanical engineering general discussion
