Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Shark21

  1. Shark21

    Pipe rated at 5000psi for pressure vessel

    Never mind. I got it figured out.
  2. Shark21

    Pipe rated at 5000psi for pressure vessel

    I am designing a pressure vessel with a 5000psi MAWP. I an trying to put in a couple of 2NPS pipes init. I am currently using SA-106B/C pipe but am falling just shy of the 5000psi pressure. Is there another pipe spec that I can use that is good for ASME?
  3. Shark21

    Quick Opening Closure for 5000psi vessel

    We are designing a vertical pressure vessel and are in need of a quick opening closure. This will act like a top removeable head. The vessel has a design pressure of 5000psi. Does anybosy know of a company that manufactures closures at this pressure? The closest that I've found is 4500psi.
  4. Shark21

    SA-36 Temperature / Yield

    Thanks again metengr. You were a big help.
  5. Shark21

    SA-36 Temperature / Yield

    Thanks all. Is there a material recommended which can withstand that kind of temperature?
  6. Shark21

    SA-36 Temperature / Yield

    I am trying to locate (thus far unsuccessfully) data that states that A-36 material is good for up to 1300 degrees. This is not in a pressure environment; it is for an exhaust vent. So far everything that I've come across says that it is only good for 750 - 850 F before creep kicks in. If that...
See more

Part and Inventory Search

Back
Top Bottom