Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by sft11

  1. sft11

    Manually update expressions

    John, I tried that before writing here but it didn't help. But thanks anyway! NX 8.0.3.4 TC 8.3.3.11
  2. sft11

    Manually update expressions

    Hi, thanks a lot that seems to do the trick! NX 8.0.3.4 TC 8.3.3.11
  3. sft11

    Manually update expressions

    Hi, is it somehow possible to force expressions update or re-evaluate the formulas in the expressions. I'm having problem in one drawing where some of the expressions stopped to update whenever the related expressions were changed. Please see the attached file! The expression "Cx_5_R1" wont...
  4. sft11

    Drawing opening problem

    Model was made with native NX and then imported to Teamcenter at some point. Drawing was made directly to Teamcenter. Does that make some difference if models are imported?
  5. sft11

    Drawing opening problem

    Thanks guys for your prompt replies! I already tried those load options but those didn't make any difference. We are using NX in teamcenter environment and we are able to load 3 rollback versions of our NX files. But there was the same issue with all of those (maybe I'm too used to not that...
  6. sft11

    Drawing opening problem

    Hello I'm having following problem when trying to open drawing. Informarion window says "The following circular update was detected:" and in the pop-up window it says "The following files could not be loaded causing this open to fail:" "There is an object which depends on itself" Most likely...
See more

Part and Inventory Search

Back
Top