Hi ewh,
Will tangent to three circles result in R13.72?-the arc less than R13.72, but one point of it is drawn by R13.72. Would a drawing indicating the same as the dimensioned view just to get the tangent?
Will condition B allow for R13.72?-yes, there is a small arc between two fillets in R13.72.
Hi,
I' confuse with the drawing which i had attached. Please refer to the red arc in the drawing only as reference, the blueprint shown the red arc with 13.72R from the center. And there is a statement which mentioned 'ALL OUTSIDE FILLET RADII 2.54 - 3.55'.
Should it be in condition A or...
