Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by segarally

  1. segarally

    Compaction effect vs. shear strength

    Thank you both! This is very helpful.
  2. segarally

    Compaction effect vs. shear strength

    I always wonder what's the basis when engineers specify 90% or 95% compaction for trench or embankment, etc. Are we using the compaction as and index property for shear strength? What if we don't have the correlation between compaction and shear strength for that material? How do we know if the...
  3. segarally

    Why Plate Load Test requires staged loads?

    Ashjun, What are the other "original" procedures? Can you explain your point in more details? Thanks.
  4. segarally

    Why Plate Load Test requires staged loads?

    Focht3, thank you for the speedy reply. If no pore pressure is involved and the data acquisition system is automated, can I use continuous loading instead of staged loading? Is the partial bearing capacity failure you mentioned same as local shear failure or punching shear failure? Also, I guess...
  5. segarally

    Why Plate Load Test requires staged loads?

    Hi,All I am reading ASTM standard of plate load test (ASTM D1194-94) in which the estimated total load is divided into at least ten steps and the time interval between two load increment is no less than 15 min. My question is what is the purpose to divide the total load into several steps...
See more

Part and Inventory Search

Back
Top