Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ScottS

  1. ScottS

    what is bearing wobble?

    Is it the cone angle the inner race traces with respect to the outer race? How is it minimized in single bearing applications? Thanks Scott
  2. ScottS

    Thermal actuated pressure relief valve

    I'm am looking for a pressure relief valve that is actuated at a set temperture. ie the device remains closed until it reaches 150F at wich point pressure is released. Does anyone know of such a device? Thanks Scott
  3. ScottS

    Rendering question

    I need to make a photo realistic rendering of an assembly but my renderings look washed out and lack details. Can anyone give me some tips on rendering and/or a resource to pull info off of? Thanx Scott
  4. ScottS

    Rofin-Sinar Experiences

    Trumpf is the biggest laser company out there but pricy. Rofin CO2 slab laser have an excellent mode which is good for cutting but don't know how essential it is for marking glass. Scott
  5. ScottS

    Jagged Edge on SS w/N2 assist

    A couple of other points. The beam could be wondering inside the tip do to misalignment or laser resonator problems. As Dan pointed out gas flow is also very important. Does it always happen on the same spot on the machine or is it random and can it happen anywhere? Scott
  6. ScottS

    SLOW INTRALINK

    I'm having problems with intralink running extremely slow. My task manager's status reads, "not responding" for long periods of time. This happens at all different times but one example is when I'm saving a part or assembly. I have a dual 800Mhz processors and 512Mb RAM so I should...
  7. ScottS

    Configuration of Pro-E

    I'm fairly new to Pro-E and have a few questions regarding its configuration. How do I configure it so the model comes up solid instead of wire frame? How do I set it so all datum’s are turned off when I open a file for the first time? How do I set the view performance to default to the settings...
  8. ScottS

    Particle Collecting in Laser Etching

    You might want to look at www.exair.com. They make air amplifiers that I have used in similar applications.
  9. ScottS

    Threading material

    The threads are not really galling but they are binding over time. There is some debris getting by our seals and we have plans to use different seals but I'm not convinced that this is the sole cause of the problem. What might be occuring is they might be drying out, making them very susceptible...
  10. ScottS

    Threading material

    We are having an unusually high failure rate in one of our products. The components are both made of 303 S.S. and are held together by a 2"-20 unc-3A thread. The environment in which they are used is very harsh and we have tried to keep them as clean as possible but the threads are still...
  11. ScottS

    Engineering Standards

    I've been given the task of re-organizing our engineering department. My company is small (35 people) It started as a Mama and Papa operation and has grown very quickly. With this quick growth the engineering department ran with very little documentation. We do mostly low volume custom parts. I...
See more

Part and Inventory Search

Back
Top